全部

1·For the fault location and structural return loss (SRL) measurement function.

供了故障定位和结构回波损耗(SRL)测量功能。

2·This paper discusses the return loss in air-space type fixed optical attenuator.

本文讨论了空气隙型光固定衰减器的回波损耗。

3·Several kinds of measurement principles and methods for optical return loss (ORL) are introduced.

介绍了几种光回波损耗的测量原理和测量方法。

4·The micro periodic non uniformity produced in the manufacturing process will cause significant return loss.

由挤塑过程所引起的微小的周期性不均匀将产生极大的反射损耗。

5·Fault location or DTF mode indicates VSWR or Return Loss levels at each point along the cable and antenna system length.

故障定位或DTF模式指示驻波比或回波损耗水平在各点沿电缆长度和天线系统。

6·It possesses of the advantages of high Echo Return Loss Enhancement and good adaptability to circuitry condition experimentally.

实验表明，该回波抵消器具有回波抑制能力强、线路环境适应性好等特点。

7·The synthesis of the cross coupled filter is from prescribed transmission zeros and return loss till the attainment of the coupling matrix of each cavity.

交叉耦合滤波器的综合从给定的传输零点和回波损耗出发，直到得到各腔体之间的耦合系数。

8·Results show that different EBG structures have different effects on the patch antenna. The performance such as gain, bandwidth and return loss of the conventiona…

结果表明基于基底打孔型方形孔EBG结构的贴片天线的性能最佳，其增益、带宽和输入回波损耗都得到了较大的改善。

9·A new broadband slot antenna with a fan-shaped microstrip feed is presented, and the return loss curve and radiation patterns of the antenna is simulated in this paper.

介绍了一种新型的采用扇形微带馈源的宽带缝隙天线，给出了反射损失曲线和辐射方向图。

10·Except a return Loss measurement is made by injecting a DM signal into the pair and measuring the DM signal returned. Here we are measuring the CM signal returned which is TCL.

回波损耗测试是通过向双绞线注入DM(差模信号)然后测试返回的DM信号，然而TCL是测试CM信号。